Most Important Tips for Buying a Used MRI

Of all the information and knowledge you’ve absorbed throughout your years in med school, buying a used MRI was probably not one of them. Fortunately, we’ve composed a breakdown of important facts and tips you can memorize (don’t worry, there is no exam on this) or have at hand when you are ready to purchase an used MRI.

1. When you purchase a used MRI, consider the importance of the magnet, gradient system, and the computer.

• The MRI magnet should produce a consistent magnetic field, cover as wide a field of view as possible, and provide ample patient space.
•  The image resolution is higher when the gradient system is faster, which also leads to the field of view being smaller.
• The computer system for an MRI is designed to keep up with the magnet so images are instantly available as the scan progresses.

2. Careful site selection is mandatory for all MRI units. Be sure to cover all the potential safety measures in early design considerations before the purchase of MRI systems, because they raise the cost of construction. Implementation following an installation may be even more costly.

3. Remember that MRI site requirements are specific to each organization. The key issues for site requirements are the examination of the extent of the magnetic field, the area occupied by the magnet, and the weight of the magnet.

4. When selecting your site, consider the fringe field and the need for a site that is free from ambient Radio Frequency (RF) noise.

• A permanent magnet has a minimal fringe field, but needs careful planning due to its massive weight. Remember, the fringe field could cause problems without proper shielding.
• External ambient RF energy signals can degrade MRI image quality, therefore RF shielding is critical. Shielding in a room typically consists of copper or aluminum sheets.

5. To tackle the problems associated with the fringe field, you can use active shielding, close-fitting steel shields integral to the magnet, or passive shielding using steel in the walls around the magnet. Those who install large steel sheets of magnetic shielding should bear in mind that these are costly, and require special construction techniques because of the weight.

6. Since fringe fields are 3-dimensional, areas on the floors above and below the imaging facility may also need controlled access and/or shielding. Actively shielded magnets have significantly reduced fringe fields and generally do not require steel shielding. Generally, the size of the controlled access area for an MRI unit increases as the operational field strength increases for the fringe fields created by superconducting and resistive magnets.